Frayed or snapped lift cable? We safely decompress the spring system and replace cables on the same visit.
Lift cables run from the bottom corner brackets up through pulleys to the cable drum. A fraying or snapped cable can drop the door unevenly and jam the track. Our Burlington technicians fully decompress the spring system before any cable work — never a shortcut — and replace cables matched to your door's weight and height.
We never touch a cable on a loaded spring. Full decompression comes first, every time.
Diameter and length are matched to your door — an incorrect cable throws off the drum wrap and travel.
We check both for wear so your new cable isn't running against a damaged surface.
Burlington stretches from the lakefront and Aldershot to Orchard, Millcroft and Alton Village, and the garage doors across the city vary as much as the neighborhoods. This guide explains what matters for the service on this page and how we approach it in Burlington homes.
Lift cables connect the bottom corners of the door to the drums above, carrying the load as the door moves. Frayed strands, rust near the bottom brackets or a door that hangs lower on one side are early signs of a cable problem.
Safe cable work begins with fully releasing the spring tension. We then replace the cable, inspect the drum and pulley for wear, and rebalance the door so it travels evenly.
Cold winters, freeze-thaw cycles and humid summers all affect garage doors. Metal parts contract in the cold, lubricants thicken, and rubber seals stiffen and crack. Homes closer to the lake can also see more moisture, which speeds up rust on exposed hardware.
Seasonal habits help. Keep the bottom seal clear of ice, avoid forcing a frozen door with the opener, and have the door inspected before winter so small problems do not turn into a stuck door on a cold morning.
Older streets in Aldershot and near the lake often have doors that have been repaired several times, while newer subdivisions in Orchard, Alton Village and Millcroft have builder-grade double-car doors with chain-drive openers. Each needs a slightly different approach to parts, balance and noise.
Our trucks carry parts for both, so we can usually complete the work during the first visit. If a part is discontinued, we source a compatible equivalent built to the same specification.
Call when the door makes new noises, moves unevenly, struggles to lift, or stops responding. Stop using the door if you suspect a broken spring, cable or off-track section, because continued use can cause more damage or injury.
A dispatcher takes your details and sends the closest available technician. The technician inspects the door, explains the cause, quotes the job in writing, and tests the full travel and safety reversal after the work is finished.
If you are not sure what your garage door needs, call us or send a request. We will explain the cause in plain language and give you a written quote before any work begins.
Call for same-day service or request a free written estimate.
